Puretone Accessory & Lab Equipment Catalogue NP - Flipbook - Page 138
138
3D Manufacture
3D Printing Guide
Smart Optics 3D Scanner
The scanner is needed to scan the physical impression.
You can scan a binaural pair of impressions within 85-95 seconds.
MONO (SMART003)
Single Impression
DUO (SMART001)
Binaural Impressions
(85-90 secs)
FREE STAGE (SMART014)
Binaural Impressions
(60-70 secs)
Cyfex Modelling Software
Open the scanned impression in the modelling software (Cyfex recommended) to transform the impression
into the actual mould/shell/cast you require, using simple pre-set templates, converted within a few minutes.
Asiga Printer & Luxaprint Material
Open the modelled impression in the Asiga
software (provided) and place the moulds
within the build platform (auto placement).
Then send the print through to the printer.
Average print time is around 2 hours but can
be increased/decreased depending on the
settings you choose. Materials available are
shell, mould or cast material.
Recommend material is Detax Luxaprint.
Materials available are shell, mould, flex or
cast material.
Effica® E1
Oven
Once printed remove the built parts and place in
the ultrasonic cleaner filled with Isopropanol for 3
minutes to clean the excess, vent holes etc.
Place in the oven for 30 minutes at 40 degrees.
This removes any sticky residue and hardens
the part.
Lacquer Shell AC
Flash Unit
PRO154A
Laquer using Detax Shell AC. Cure the laquer
under UV light for approx. 4 minutes.
Place in the flash unit to ensure material is fully
cured. 5-10 minutes with the Asiga flash unit.
G171 flash unit is recommended.
Always follow material manufacturers instructions
+44 (0)1634 733883
sales@puretone.net
www.puretone.net
